ATV212WD37N4 - Variable speed drive ATV212 37kW 50hp 480V 3ph EMC class C2 IP55 - Schneider Electric
+/- 0.6 % (VIB) for a temperature variation 60 °C
+/- 1 % (FM) for a temperature variation 60 °C
5 A at 30 V DC on resistive load - cos phi = 1 - L/R = 0 ms (FL, R)
2 A at 250 V AC on inductive load - cos phi = 0.4 - L/R = 7 ms (FL, R)
2 A at 30 V DC on inductive load - cos phi = 0.4 - L/R = 7 ms (FL, R)
UL
C-Tick
CSA
FLA, FLC 7 ms, tolerance +/- 0.5 ms for discrete output(s)
FLB, FLC 7 ms, tolerance +/- 0.5 ms for discrete output(s)
RY, RC 7 ms, tolerance +/- 0.5 ms for discrete output(s)
24 N.m, 212 lb.in (L1/R, L2/S, L3/T)
VIB configurable voltage: 0...10 V DC 24 V max, impedance: 30000 Ohm, resolution 10 bits
VIB configurable PTC probe: 0...6 probes, impedance: 1500 Ohm
VIA switch-configurable current: 0...20 mA, impedance: 250 Ohm, resolution 10 bits
Flux vector control without sensor, standard
Voltage/frequency ratio, 2 points
Voltage/frequency ratio, 5 points
Voltage/frequency ratio - Energy Saving, quadratic U/f
Negative logic (sink) (F, R, RES), >= 16 V (state 0), <= 10 V (state 1)
FM switch-configurable current 0...20 mA, impedance: 970 Ohm, resolution 10 bits
R programmable 24 V DC, with level 1 PLC, impedance: 4700 Ohm
RES programmable 24 V DC, with level 1 PLC, impedance: 4700 Ohm
8...16 kHz with derating factor
Adjustable
Automatic whatever the load
Configurable relay logic: (FLB, FLC) NC - 100000 cycles
Configurable relay logic: (RY, RC) NO - 100000 cycles
Monitoring inhibitable
Write single register (06)
Write multiple registers (16) 2 words maximum
Read device identification (43)
Time out setting from 0.1 to 100 s
Modbus
APOGEE FLN
METASYS N2
BACnet
1 RJ45
54.4 A at 480 V
79 A at 460 V
L1/R, L2/S, L3/T: terminal 50 mm² / AWG 1/0
VIB: +/- 0.15 % of maximum value for input
FM: +/- 0.2 % for output
5092 V DC between control and power terminals
Internal supply: 24 V DC (21…27 V), <200 A, protection type: overload and short-circuit protection
Automatic based on the load
Thermal power stage: drive
Short-circuit between motor phases: drive
Input phase breaks: drive
Overcurrent between output phases and earth: drive
Overvoltages on the DC bus: drive
Break on the control circuit: drive
Against exceeding limit speed: drive
Line supply overvoltage and undervoltage: drive
Line supply undervoltage: drive
Against input phase loss: drive
Thermal protection: motor
Motor phase break: motor
With PTC probes: motor
Analog input: 0.024/50 Hz
2 ms +/- 0.5 ms R discrete
2 ms +/- 0.5 ms RES discrete
3.5 ms +/- 0.5 ms VIA analog
22 ms +/- 0.5 ms VIB analog
Without mounting kit: 1 wire(s)IEC cable at 45 °C, copper 70 °C / PVC
With UL Type 1 kit: 3 wire(s)UL 508 cable at 40 °C, copper 75 °C / PVC
IP55 conforming to EN/IEC 60529
<= 1000 m without derating
40…50 °C (with derating factor)
Radiated radio-frequency electromagnetic field immunity test level 3 conforming to IEC 61000-4-3
Electrical fast transient/burst immunity test level 4 conforming to IEC 61000-4-4
1.2/50 µs - 8/20 µs surge immunity test level 3 conforming to IEC 61000-4-5
Conducted radio-frequency immunity test level 3 conforming to IEC 61000-4-6
Voltage dips and interruptions immunity test conforming to IEC 61000-4-11
Classes 3S2 conforming to IEC 60721-3-3
IEC 61800-5-1
EN 61800-3 environments 1 category C3
IEC 61800-3 environments 2 category C2
IEC 61800-3 environments 2 category C1
IEC 61800-3
EN 61800-3 environments 1 category C2
EN 55011 class A group 1
EN 61800-3 environments 1 category C1
EN 61800-3 category C2
IEC 61800-3 environments 1 category C3
IEC 61800-3 category C3
IEC 61800-3 category C2
IEC 61800-3 environments 1 category C2
EN 61800-3 environments 2 category C2
IEC 61800-3 environments 2 category C3
EN 61800-3 category C3
EN 61800-3 environments 2 category C3
EN 61800-3 environments 2 category C1
EN 61800-5-1
IEC 61800-3 environments 1 category C1
5…95 % without dripping water conforming to IEC 60068-2-3
1 gn (f= 13…200 Hz) conforming to EN/IEC 60068-2-8
The ATV212WD37N4 - Variable speed drive ATV212 37kW 50hp 480V 3ph EMC class C2 IP55 is created to meet the needs of technical experts, such as installers, wiremen, repair companies, and primary equipment makers. ATV212WD37N4 delivers first-rate quality and gain for technicians in the electrical and automation industry. This Variable speed drive ATV212 37kW 50hp 480V 3ph EMC class C2 IP55 and other Altivar 212 from Schneider Electric can be acquired at the lowest cost and procurement time through BALTELEC website, a dependable provider supporting technicians in their obtaining needs.
Technicians who have purchased Schneider Electric Altivar 212 have invariably approved the creator's durability. It has been remarked that the exceptional workmanship of ATV212WD37N4 - Variable speed drive ATV212 37kW 50hp 480V 3ph EMC class C2 IP55 extends to a collection of deployments. Its superior specifications make it great selection to meet diverse demands, guaranteeing the success of your industrial, tertiary, and automation contracts.
Our professionals commits in serving industrial and tertiary professionals’ needs. We recognize the individual specifications and desires of our patrons in the domain. By aligning with our professionals, your organization access access to the best price lists and delivery schedule of premium products like ATV212WD37N4 - Variable speed drive ATV212 37kW 50hp 480V 3ph EMC class C2 IP55 from Schneider Electric at a reasonable price. Our registered accounts benefit from more savings and expedited requests handling.
Begin today and grab ATV212WD37N4 - Variable speed drive ATV212 37kW 50hp 480V 3ph EMC class C2 IP55 at our safe and hassle-free platform. Don't delay in making this sensible option that assures the highest quality and achieves the specific demands of suppliers like your enterprise.
If you possess any doubts or concerns about ATV212WD37N4 - Variable speed drive ATV212 37kW 50hp 480V 3ph EMC class C2 IP55 or any other Schneider Electric products, call us or refer to our Assistance center section below. We have consolidated answers to regular doubts to assist you further in making an educated decision about industrial and tertiary electrical components.
Remember, ATV212WD37N4 - Variable speed drive ATV212 37kW 50hp 480V 3ph EMC class C2 IP55 from Schneider Electric is dependable, cost-effective, and top-notch to alternative suppliers in the Altivar 212 category. Make it a part of your installation at once. Procure at baltele.eu, your consistent provider for all your Schneider Electric.
In our Baltelec.eu virtual store you will find Variable speed drive ATV212 37kW 50hp 480V 3ph EMC class C2 IP55 - ATV212WD37N4 worth 4,540.47 €, which will be a faithful and modern solution for your expectations. This article is formulated by the Schneider Electric brand using the freshest technologies and fulfills the maximum standards of reliability and efficiency. We give articles from the Altivar 212 category that mix lastingness and efficacy, which is an outstanding possibility for various operations. In spite of whether you seek instruments for small output or for adept industrial utilization, Variable speed drive ATV212 37kW 50hp 480V 3ph EMC class C2 IP55 will be a constant assistant in your assignment.
Baltelec aims to make the procuring process as easy and fast as viable for our buyers. We offer detailed outlines and high-quality portrayals of Variable speed drive ATV212 37kW 50hp 480V 3ph EMC class C2 IP55 so that you can make an informed choice. A team of pros is always ready to help you with any queries in the Altivar 212 section linked to the determining and use of wares. We are assured that Variable speed drive ATV212 37kW 50hp 480V 3ph EMC class C2 IP55 will meet your demands and become an essential element of your tools for just 4,540.47 €.
Frequently Raised Questions about ATV212WD37N4 - Variable speed drive ATV212 37kW 50hp 480V 3ph EMC class C2 IP55:
-
What are the benefits of purchasing ATV212WD37N4 from Baltelec website?
When buying ATV212WD37N4 from Baltelec online store, you will get authentic quality Schneider Electric Altivar 212 products at affordable prices and lead time. Additionally, registered accountsget additional savings and expedited requests handling.
-
What is the way to find out if Schneider Electric Variable speed drive ATV212 37kW 50hp 480V 3ph EMC class C2 IP55 suits for my technical requirements?
To make sure that ATV212WD37N4 matches your use case, we offer thorough details regarding product's specs, technical characteristics, and applicable standards. You can find this information on the dedicated page of the device name. If you require more guidance, our customer support team is prepared to assist you in making an educated choice.
-
Which warranty coverage is offered for ATV212WD37N4 - Variable speed drive ATV212 37kW 50hp 480V 3ph EMC class C2 IP55?
BaltElec is committed to the reliability of the items we sell. The default guarantee coverage for Schneider Electric Altivar 212 including ATV212WD37N4 is 1 year. However, it depends based on the individual item, product category, and could be extended. You can discover detailed guarantee information on the Schneider Electric Variable speed drive ATV212 37kW 50hp 480V 3ph EMC class C2 IP55 dedicated page or by contacting our customer service team.
-
Do you arrange worldwide shipping for ATV212WD37N4 - Variable speed drive ATV212 37kW 50hp 480V 3ph EMC class C2 IP55 and other Schneider Electric items?
Absolutely. In addition to serving Estonia, Latvia, Lithuania and other European Union countries, we offer worldwide shipping for ATV212WD37N4. Please note that shipping options, fees, and shipping times may vary based on the destination. For volume requests, kindly contact BaltElec sales representatives.
-
Do Schneider Electric MBC provided by BALTELEC meet global norms for safety and reliability?
Certainly. All Schneider Electric items provided at BALTELEC web store adhere to global standards such as IEC 60898-1 and carry the CE mark. Such standards ensure that the products meet strict security, technological, dependability, and performance criteria.
-
Can BALTELEC offer guidance on integrating renewable energy solutions, such as solar power systems or wind energy converters, into my projects?
Yes, sure! Baltelec.eu website understands the relevance of renewable energy integration within community. Our group of experts can support you in selecting the appropriate Schneider Electric products, to incorporate them into your renewable energy projects}. We can offer advice on combining solar energy systems, wind energy converters, and other sustainable options to optimize power generation and effectiveness.
-
Do you have green options offered within the Altivar 212 category to promote energy conservation efforts?
Definitely!Yes! BaltElec offers various energy-efficient solutions in the category of Altivar 212 that align with environmental sustainability objectives. Our brand's Schneider Electric products, like the ATV212WD37N4, are crafted with environmental friendliness in mind. By incorporating these products into your electrical system, you can enhance energy usage and lower environmental impact. Additionally, we offer attractive pricing for our green Schneider Electric products,, making them an economical choice for promoting sustainability.
-
Are Variable speed drive ATV212 37kW 50hp 480V 3ph EMC class C2 IP55 available by BALTELEC legitimate?
Yes, we exclusively provide genuine Schneider Electric products, including but not limited to Variable speed drive ATV212 37kW 50hp 480V 3ph EMC class C2 IP55. We obtain our products exclusively through official distribution channels to guarantee their authenticity and excellent performance.
