ATV212HU75N4 - Variable speed drive ATV212 7.5kW 10hp 480V 3ph EMC IP21 - Schneider Electric
+/- 0.6 % (VIB) for a temperature variation 60 °C
+/- 1 % (FM) for a temperature variation 60 °C
5 A at 30 V DC on resistive load - cos phi = 1 - L/R = 0 ms (FL, R)
2 A at 250 V AC on inductive load - cos phi = 0.4 - L/R = 7 ms (FL, R)
2 A at 30 V DC on inductive load - cos phi = 0.4 - L/R = 7 ms (FL, R)
NOM 117
UL
CSA
FLA, FLC 7 ms, tolerance +/- 0.5 ms for discrete output(s)
FLB, FLC 7 ms, tolerance +/- 0.5 ms for discrete output(s)
RY, RC 7 ms, tolerance +/- 0.5 ms for discrete output(s)
2.5 N.m, 22 lb.in (L1/R, L2/S, L3/T)
VIB configurable voltage: 0...10 V DC 24 V max, impedance: 30000 Ohm, resolution 10 bits
VIB configurable PTC probe: 0...6 probes, impedance: 1500 Ohm
VIA switch-configurable current: 0...20 mA, impedance: 250 Ohm, resolution 10 bits
Voltage/frequency ratio, automatic IR compensation (U/f + automatic Uo)
Flux vector control without sensor, standard
Voltage/frequency ratio, 5 points
Voltage/frequency ratio, 2 points
Negative logic (sink) (F, R, RES), >= 16 V (state 0), <= 10 V (state 1)
FM switch-configurable current 0...20 mA, impedance: 970 Ohm, resolution 10 bits
R programmable 24 V DC, with level 1 PLC, impedance: 4700 Ohm
RES programmable 24 V DC, with level 1 PLC, impedance: 4700 Ohm
12...16 kHz with derating factor
Automatic whatever the load
Adjustable
Configurable relay logic: (FLB, FLC) NC - 100000 cycles
Configurable relay logic: (RY, RC) NO - 100000 cycles
Read holding registers (03) 2 words maximum
Write multiple registers (16) 2 words maximum
Write single register (06)
Read device identification (43)
Time out setting from 0.1 to 100 s
LonWorks
BACnet
METASYS N2
Modbus
1 RJ45
14.7 A at 380 V
16 A at 460 V
7…11 kW at 480…500 V 3 phases
L1/R, L2/S, L3/T: terminal 16 mm² / AWG 6
VIB: +/- 0.15 % of maximum value for input
FM: +/- 0.2 % for output
5092 V DC between control and power terminals
Internal supply: 24 V DC (21…27 V), <200 A, protection type: overload and short-circuit protection
Building - HVAC fan
Building - HVAC pump
Automatic based on the load
Thermal power stage: drive
Short-circuit between motor phases: drive
Input phase breaks: drive
Overcurrent between output phases and earth: drive
Overvoltages on the DC bus: drive
Break on the control circuit: drive
Against exceeding limit speed: drive
Line supply overvoltage and undervoltage: drive
Line supply undervoltage: drive
Against input phase loss: drive
Thermal protection: motor
Motor phase break: motor
With PTC probes: motor
Analog input: 0.024/50 Hz
2 ms +/- 0.5 ms R discrete
2 ms +/- 0.5 ms RES discrete
3.5 ms +/- 0.5 ms VIA analog
22 ms +/- 0.5 ms VIB analog
Without mounting kit: 1 wire(s)IEC cable at 45 °C, copper 70 °C / PVC
With UL Type 1 kit: 3 wire(s)UL 508 cable at 40 °C, copper 75 °C / PVC
IP20 on upper part without blanking plate on cover conforming to EN/IEC 60529
IP21 conforming to EN/IEC 61800-5-1
IP21 conforming to EN/IEC 60529
IP41 on upper part conforming to EN/IEC 61800-5-1
IP41 on upper part conforming to EN/IEC 60529
<= 1000 m without derating
40…50 °C (with derating factor)
Radiated radio-frequency electromagnetic field immunity test level 3 conforming to IEC 61000-4-3
Electrical fast transient/burst immunity test level 4 conforming to IEC 61000-4-4
1.2/50 µs - 8/20 µs surge immunity test level 3 conforming to IEC 61000-4-5
Conducted radio-frequency immunity test level 3 conforming to IEC 61000-4-6
Voltage dips and interruptions immunity test conforming to IEC 61000-4-11
Classes 3S2 conforming to IEC 60721-3-3
EN 61800-3 environments 1 category C1
IEC 61800-3 category C3
IEC 61800-5-1
IEC 61800-3 category C2
IEC 61800-3 environments 1 category C2
EN 61800-3 environments 2 category C2
EN 61800-3 environments 1 category C2
EN 61800-3 category C2
EN 61800-3 category C3
EN 61800-3 environments 2 category C3
IEC 61800-3 environments 1 category C3
UL Type 1
IEC 61800-3 environments 2 category C2
EN 61800-3 environments 1 category C3
IEC 61800-3 environments 2 category C1
EN 55011 class A group 1
EN 61800-3 environments 2 category C1
EN 61800-5-1
IEC 61800-3 environments 2 category C3
IEC 61800-3
IEC 61800-3 environments 1 category C1
5…95 % without dripping water conforming to IEC 60068-2-3
1 gn (f= 13…200 Hz) conforming to EN/IEC 60068-2-8
The ATV212HU75N4 - Variable speed drive ATV212 7.5kW 10hp 480V 3ph EMC IP21 is conceived to serve the wants of professional purchasers, such as panel builders, wiring experts, repair companies, and industry fabricators. ATV212HU75N4 offers unmatched standards and gain for contractors in the power engineering industry. This Variable speed drive ATV212 7.5kW 10hp 480V 3ph EMC IP21 and other Altivar 212 from Schneider Electric are on offer at the unbeatable price and distribution time through BaltElec, a trustworthy provider catering to technicians in their provision needs.
Clients who have opted for Schneider Electric Altivar 212 have continuously approved the brand's robustness. It has been specified that the notable capability of ATV212HU75N4 - Variable speed drive ATV212 7.5kW 10hp 480V 3ph EMC IP21 extends to a extensive scope of deployments. Its first-rate characteristics make it proper pick for wide-ranging specifications, securing success in your industrial, tertiary, and automation endeavors.
Our company concentrates in addressing industrial and tertiary professionals’ needs. We recognize the customized criteria and anticipations of our consumers in the industry. By partnering with our company, your business secure access to the top rates and inventory of superior products like ATV212HU75N4 - Variable speed drive ATV212 7.5kW 10hp 480V 3ph EMC IP21 from Schneider Electric at an economical price. Baltelec account members enjoy added discounts and dedicated support.
Begin today and buy ATV212HU75N4 - Variable speed drive ATV212 7.5kW 10hp 480V 3ph EMC IP21 at our well-established and streamlined digital marketplace. Don't delay in making this astute selection that confirms the best quality and meets the customized standards of users like your enterprise.
If there are any issues or concerns about ATV212HU75N4 - Variable speed drive ATV212 7.5kW 10hp 480V 3ph EMC IP21 or any other Schneider Electric products, get in touch with us or refer to our Support section section below. We have consolidated answers to regular questions to serve you further in making an educated decision about industrial and tertiary electrical components.
Remember, ATV212HU75N4 - Variable speed drive ATV212 7.5kW 10hp 480V 3ph EMC IP21 from Schneider Electric is dependable, low-cost, and premier to other vendors in the Altivar 212 category. Make it a part of your network at once. Get at Baltelec webstore, your faithful dealer for all your professional electrical equipment and automation needs.
In our Baltelec.eu e-commerce store you will locate Variable speed drive ATV212 7.5kW 10hp 480V 3ph EMC IP21 - ATV212HU75N4 worth 1,092.92 €, which will be a constant and cutting-edge solution for your wishes. This thing is produced by the Schneider Electric brand using the advanced technologies and conforms to the uppermost standards of well-being and capability. We present items from the Altivar 212 category that fuse strength and workability, which is an fine possibility for various objectives. Without consideration of whether you seek apparatus for small formation or for specialized industrial utilization, Variable speed drive ATV212 7.5kW 10hp 480V 3ph EMC IP21 will be a reliable assistant in your job.
Baltelec tries to make the attaining process as comfortable and fast as workable for our buyers. We offer detailed narratives and high-quality visuals of Variable speed drive ATV212 7.5kW 10hp 480V 3ph EMC IP21 so that you can make an versed choice. A team of specialists is always ready to help you with any doubts in the Altivar 212 section involved to the choosing and use of supplies. We are affirmed that Variable speed drive ATV212 7.5kW 10hp 480V 3ph EMC IP21 will meet your hopes and become an essential element of your gear for just 1,092.92 €.
Customer Queries about Schneider Electric ATV212HU75N4:
-
Why should I buy ATV212HU75N4 from baltelec.eu?
When ordering Schneider Electric ATV212HU75N4 from Baltelec, you obtain original high-quality Schneider Electric Altivar 212 products at competitive prices and lead time. Furthermore, our partnerstake pleasure in further discounts and priority service.
-
Can Baltelec advise if ATV212HU75N4 is the right choice for my technical requirements?
To confirm that Schneider Electric ATV212HU75N4 is suitable for your drawings, we provide thorough details pertaining to product's specs, technical characteristics, and applicable standards. You can access this data on the specific page of the product name. If you seek further assistance, our customer support representative stands ready to assist you in reaching an informed choice.
-
What warranty coverage is provided for ATV212HU75N4?
BALTELEC emphasizes the reliability of the products we sell. The regular warranty coverage for Schneider Electric Altivar 212 including ATV212HU75N4 - Variable speed drive ATV212 7.5kW 10hp 480V 3ph EMC IP21 is 1 year. Nevertheless, it depends according to the particular product, category, and might be longer. You can discover detailed guarantee details on the ATV212HU75N4 - Variable speed drive ATV212 7.5kW 10hp 480V 3ph EMC IP21 dedicated page or by contacting our support team representatives.
-
Can you provide international shipping for Schneider Electric Variable speed drive ATV212 7.5kW 10hp 480V 3ph EMC IP21 and other Schneider Electric products?
Absolutely. Apart from catering to Estonia, Latvia, Lithuania and other European Union countries, we provide worldwide shipping for Schneider Electric Variable speed drive ATV212 7.5kW 10hp 480V 3ph EMC IP21. Please be aware that shipping options, fees, and delivery schedule might vary depending on the shipping location. In the case of complex inquiries, feel free to reach out to BALTELEC sales representatives.
-
Do Schneider Electric MBC provided by BALTELEC comply with global norms for security and reliability?
Of course. All Schneider Electric items offered at Baltelec web store adhere to international standards such as IEC 60898-1 and carry the CE mark. These norms ensure that the items fulfill strict safety, technological, dependability, and functional requirements.
-
Can Baltelec.eu offer support on incorporating renewable energy solutions, such as solar energy systems or wind power converters, into my projects?
Yes! Baltelec website recognizes the importance of renewable energy integration within projects. Our team of professionals can help you in choosing the appropriate Schneider Electric items, to incorporate them into your renewable energy solutions}. We can offer advice on integrating solar energy systems, wind energy converters, and other eco-friendly options to optimize energy generation and effectiveness.
-
Are there eco-friendly options available within the Altivar 212 category to encourage environmental sustainability?
Absolutely! Baltelec.eu online store provides numerous green solutions in the category of Altivar 212 that are in line with environmental sustainability objectives. Our top-quality Schneider Electric products, like the ATV212HU75N4, are engineered with energy conservation in mind. By integrating these products into your electrical system, you can maximize energy usage and minimize environmental impact. Additionally, we present attractive pricing for our green Schneider Electric products,, making them an cost-effective choice for advocating sustainability.
-
Are ATV212HU75N4 offered by BaltElec legitimate?
Yes, we solely sell original Schneider Electric products, including but not limited to ATV212HU75N4. We procure our products exclusively through official distribution channels to ensure their legitimacy and superior standards.
